Carbonating Vodka?
This was actually pretty hard to find. I guess people don't play with mixology. I found one guy who was carbonating apple juice for his kids. If the siphons can do apple juice, they should be able to do alcohol. A quick test with water shows you one thing: you don't want to serve the alcohol under pressure if you want it to stay fizzy. Water gets everywhere if you fill the cup at the wrong angle. To remedy this problem, I removed the stem and charged the canister. Well, the stem is a two part device. Remove the straw part and put the plug back in place, then close and charge the canister. The top part of the stem forms a seal around the top of the canister. Without it, all the air escapes! You can use up to two cartridges for a full bottle.
Shake the canister for a few seconds, then place in the refrigerator. After two hours, retrieve the alcohol bottle and a funnel. Dispense the c02 in the canister by depressing the trigger, remove the top and plastic seals, then [b]slowly[/b] pour the alcohol back into the bottle. If you pour it too quickly, it will fizz all over the counter. With a quick rinse, the siphon is ready to make carbonated water again.
Jen commented on how strong the flavors were in the foam, but how they were very balanced by the end of the drink. I guess this has to do with the air molecules in the liquid. The gelatin is unnoticeable; the drink feels the same on your tongue, well, except for the foam part. This technique can apply to just about any drink.
The only problem with the siphon is that we seem to run out of water when Jen goes to get a glass for dinner. Aidan loves sparkling water in his juice
0 TrackBacks
Listed below are links to blogs that reference this entry: Carbonating Vodka?.
TrackBack URL for this entry: http://www.sketchyskitchen.com/blog/mt-tb.cgi/59

Leave a comment